ZyXEL Communications ZYWALL 1050 - V2.00 EDITION 1 Podręcznik Użytkownika Pobierz pdf (Strona 153)

Chapter 18 L2TP VPN

ZyWALL (ZLD) CLI Reference Guide

153

18.4 L2TP VPN Commands

The following table describes the values required for some L2TP VPN commands. Other

values are discussed with the corresponding commands.

The following sections list the L2TP VPN commands.

18.4.1 L2TP VPN Commands

This table lists the commands for L2TP VPN. You must use the configure terminal

command to enter the configuration mode before you can use these commands.

Table 75 Input Values for L2TP VPN Commands

LABEL DESCRIPTION

address_object The name of an IP address (group) object. You may use 1-31 alphanumeric

characters, underscores(

_), or dashes (-), but the first character cannot be a

number. This value is case-sensitive.

interface_name The name of the interface.

Ethernet interface: For the ZyWALL USG 300 and above, use gex, x = 1 - N,

where N equals the highest numbered Ethernet interface for your ZyWALL

model.

The ZyWALLUSG 100 and 200 models use a name such as wan1, wan2,

opt, lan1, ext-wlan, or dmz.

VLAN interface: vlanx, x = 0 - 4094

bridge interface: brx, x = 0 - N, where N depends on the number of bridge

interfaces your ZyWALL model supports.

ppp_interface PPPoE/PPTP interface: pppx, x = 0 - N, where N depends on the number of

PPPoE/PPTP interfaces your ZyWALL model supports.

map_name The name of an IPSec SA. You may use 1-31 alphanumeric characters,

underscores(

_), or dashes (-), but the first character cannot be a number. This

value is case-sensitive.

user_name The name of a user (group). You may use 1-31 alphanumeric characters,

underscores(_), or dashes (-), but the first character cannot be a number. This

value is case-sensitive.

Table 76 L2TP VPN Commands

COMMAND DESCRIPTION

l2tp-over-ipsec recover

default-ipsec-policy

If the default L2TP IPSec policy has been deleted, use this command to

recreate it (with the default settings).

[no] l2tp-over-ipsec

activate;

Turns L2TP VPN on. The no command turns it off.

l2tp-over-ipsec crypto

map_name

Specifies the IPSec VPN connection the ZyWALL uses for L2TP VPN. It

must meet the requirements listed in Section 18.2 on page 151.

Note: Modifying this VPN connection (or the VPN gateway

that it uses) disconnects any existing L2TP VPN

sessions.

l2tp-over-ipsec pool

address-object

Specifies the address object that defines the pool of IP addresses that the

ZyWALL uses to assign to the L2TP VPN clients.

1 2 ... 148 149 150 151 152 153 154 155 156 157 158 ... 385 386

Komentarze do niniejszej Instrukcji

Brak uwag

ZyXEL Communications ZYWALL 1050 - V2.00 EDITION 1 Podręcznik Użytkownika Strona 153

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Bramy / kontrolery ZyXEL Communications ZYWALL 1050 - V2.00 EDITION 1