ZyXEL Communications ZYWALL 1050 - V2.00 EDITION 1 Podręcznik Użytkownika Pobierz pdf (Strona 55)

Chapter 6 Interfaces

ZyWALL (ZLD) CLI Reference Guide

This example shows how to restart an interface. You can check all interface names on the

ZyWALL. Then use either the system name or user-defined name of an interface (ge4 or

Customer in this example) to restart it.

6.2.2 DHCP Setting Commands

This table lists DHCP setting commands. DHCP is based on DHCP pools. Create a DHCP

pool if you want to assign a static IP address to a MAC address or if you want to specify the

starting IP address and pool size of a range of IP addresses that can be assigned to DHCP

clients. There are different commands for each configuration. Afterwards, in either case, you

have to bind the DHCP pool to the interface.

Router> show interface-name

No. System Name User Defined Name

===========================================================================

1 ge1 ge1

2 ge2 ge2

3 ge3 ge3

4 ge4 Customer

5 ge5 ge5

Router> configure terminal

Router(config)# interface reset ge4

Router(config)# interface reset Customer

Router(config)#

Table 17 interface Commands: DHCP Settings

COMMAND DESCRIPTION

show ip dhcp pool [profile_name] Shows information about the specified DHCP pool

or about all DHCP pools.

ip dhcp pool rename profile_name profile_name Renames the specified DHCP pool from the first

profile_name to the second profile_name.

[no] ip dhcp pool profile_name Creates a DHCP pool if necessary and enters sub-

command mode. You can use the DHCP pool to

create a static entry or to set up a range of IP

addresses to assign dynamically.

About the sub-command settings:

• If you use the

host command, the ZyWALL

treats this DHCP pool as a static DHCP entry.

• If you do not use the

host command and use

the network command, the ZyWALL treats

this DHCP pool as a pool of IP addresses.

• If you do not use the

host command or the

network command, the DHCP pool is not

properly configured and cannot be bound to

any interface.

The

no command removes the specified DHCP

pool.

show Shows information about the specified DHCP pool.

Use the following commands if you want to create

a static DHCP entry. If you do not use the host

command, the commands that are not in this

section have no effect, but you can still set them.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 385 386

Komentarze do niniejszej Instrukcji

Brak uwag

ZyXEL Communications ZYWALL 1050 - V2.00 EDITION 1 Podręcznik Użytkownika Strona 55

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Bramy / kontrolery ZyXEL Communications ZYWALL 1050 - V2.00 EDITION 1