ZyXEL Communications GS3700 Series Podręcznik Użytkownika Pobierz pdf (Strona 284)

Chapter 34 Static Route

GS3700/XGS3700 Series User’s Guide

284

34.4 Configuring IPv6 Static Routing

Click the link next to IPv6 Static Route in the IP Application > Static Routing screen to display

the screen as shown.

Figure 176 IP Application > Static Routing > IPv6 Static Route

The following table describes the related labels you use to create a static route.

Table 141 IP Application > Static Routing > IPv6 Static Route

LABEL DESCRIPTION

Route

Destination

Enter the IPv6 address of the final destination.

Prefix Length Enter the prefix length number of up to 64 for this destination.

Next Hop Enter the IPv6 address of the next-hop router.

Interface Type Select the type of the IPv6 interface through which the IPv6 packets are forwarded.

The Switch supports only the VLAN interface type at the time of writing.

Interface ID Enter the ID number of the IPv6 interface through which the IPv6 packets are forwarded.

Add Click Add to insert a new static route to the Switch’s run-time memory. The Switch loses

these changes if it is turned off or loses power, so use the Save link on the top navigation

panel to save your changes to the non-volatile memory when you are done configuring.

Cancel Click Cancel to begin configuring this screen afresh.

Index This field displays the index number of the route. Click a number to edit the static route

entry.

Interface This field displays the descriptive name of the interface that is used to forward the packets

to the destination.

Route

Destination/

Prefix Length

This field displays the IPv6 subnet prefix and prefix length of the final destination.

Next Hop This field displays the IPv6 address of the gateway that helps forward the packet to the

destination.

1 2 ... 279 280 281 282 283 284 285 286 287 288 289 ... 415 416

Brak uwag

ZyXEL Communications GS3700 Series Podręcznik Użytkownika Strona 284