ZyXEL Communications GS3700 Series Podręcznik Użytkownika Pobierz pdf (Strona 85)

Chapter 6 Basic Setting

GS3700/XGS3700 Series User’s Guide

6.9.11 DHCPv6 Client Setup

Use this screen to configure the Switch’s DHCP settings when it is acting as a DHCPv6 client. Click

the link next to IPv6 Neighbor Setup in the IPv6 Configuration screen to display the screen as

shown next.

Figure 41 Basic Setting > IPv6 > IPv6 Configuration > DHCPv6 Client Setup

The following table describes the labels in this screen.

MAC This field displays the MAC address of the neighboring device which can be reached

through the interface.

Delete Check the entry(ies) that you want to remove in the Delete column and then click

Delete to remove the selected entry(ies) from the summary table.

Cancel Click Cancel to clear the Delete check boxes.

Table 26 Basic Setting > IPv6 > IPv6 Configuration > IPv6 Neighbor Setup (continued)

LABEL DESCRIPTION

Table 27 Basic Setting > IPv6 > IPv6 Configuration > DHCPv6 Client Setup

LABEL DESCRIPTION

Interface Select the IPv6 interface you want to configure.

IA Type Select IA-NA to set the Switch to get a non-temporary IP address from the DHCPv6

server for this interface.

Optionally, you can also select Rapid-Commit to have the Switch send its DHCPv6

Solicit message with a Rapid Commit option to obtain information from the DHCPv6

server by a rapid two-message exchange. The Switch discards any Reply messages

that do not include a Rapid Commit option. The DHCPv6 server should also support the

Rapid Commit option to have it work well.

Options Select DNS to have the Switch obtain DNS server IPv6 addresses and/or select

Domain-List to have the Switch obtain a list of domain names from the DHCP server.

Information Refresh

Minimum

Specify the time interval (from 600 to 4294967295 seconds) at which the Switch

exchanges other configuration information with a DHCPv6 server again.

Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses

these changes if it is turned off or loses power, so use the Save link on the top

navigation panel to save your changes to the nonvolatile memory when you are done

configuring.

Cancel Click Cancel to begin configuring this screen afresh.

Clear Click Clear to reset the fields to the factory defaults.

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 415 416

Brak uwag

ZyXEL Communications GS3700 Series Podręcznik Użytkownika Strona 85