ZyXEL Communications P-2302HWUDL-P1 Podręcznik Użytkownika Pobierz pdf (Strona 117)

Chapter 7 LAN

P-2302HWUDL-P1 Series User’s Guide

117

7.2.3 LAN Static DHCP Screen

" This screen has no effect if the DHCP server is not enabled. You can enable it in

Network > LAN > DHCP Setup.

Use this screen to make the ZyXEL Device assign a specific IP address to a specific computer

on the LAN. To access this screen, click Network > LAN > Static DHCP.

Figure 63 Network > LAN > Static DHCP

Pool Size Enter the number of IP addresses to allocate. This number must be at least one

and is limited by a subnet mask of 255.255.255.0 (regardless of the subnet the

ZyXEL Device is in). For example, if the IP Pool Start Address is 10.10.10.10,

the ZyXEL Device can allocate up to 10.10.10.254, or 245 IP addresses.

DNS Server

First DNS Server

Second DNS

Server

Third DNS Server

Specify the IP addresses of a maximum of three DNS servers that the network can

use. The ZyXEL Device provides these IP addresses to DHCP clients. You can

specify these IP addresses two ways.

From ISP - provide the DNS servers provided by the ISP on the WAN port.

User Defined - enter a static IP address.

DNS Relay - this setting will relay DNS information from the DNS server obtained

by the ZyXEL Device.

None - no DNS service will be provided by the ZyXEL Device.

Apply

Click this to save your changes and to apply them to the ZyXEL Device.

Cancel Click this to set every field in this screen to its last-saved value.

Table 50 Network > LAN > DHCP Setup

LABEL DESCRIPTION

1 2 ... 112 113 114 115 116 117 118 119 120 121 122 ... 367 368

Brak uwag

ZyXEL Communications P-2302HWUDL-P1 Podręcznik Użytkownika Strona 117