ZyXEL Communications Parental Control Gateway HS100/HS100W Podręcznik Użytkownika Strona 270

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
Przeglądanie stron 269
HomeSafe User’s Guide
Filter Configuration 27-7
Packet
into IP Filter
Matched
Matched
Yes
Action Matched
Action Not Matched
More?
No
Filter Active?
Check
IP Protocol
Drop
Drop Packet Accept Packet
Drop Forward
Check Next Rule
Check Next Rule
Check Next Rule
Forward
Not Matched
Yes
No
Check Src
IP Addr
Apply SrcAddrMask
to Src Addr
Matched
Check Dest
IP Addr
Apply DestAddrMask
to Dest Addr
Not Matched
Not Matched
Check Src &
Dest Port
Matched
Not Matched
Figure 27-7 Executing an IP Filter
27.2.3 Configuring a Generic Filter Rule
This section shows you how to configure a generic filter rule. The purpose of generic rules is to
allow you to filter non-IP packets. For IP, it is generally easier to use the IP rules directly.
For generic rules, the HomeSafe treats a packet as a byte stream as opposed to an IP or IPX
packet. You specify the portion of the packet to check with the Offset (from 0) and the Length
fields, both in bytes. The HomeSafe applies the Mask (bit-wise ANDing) to the data portion
before comparing the result against the Value to determine a match. The Mask and Value are
specified in hexadecimal numbers. Note that it takes two hexadecimal digits to represent a byte,
so if the length is 4, the value in either field will take 8 digits, for example, FFFFFFFF.
Przeglądanie stron 269
1 2 ... 265 266 267 268 269 270 271 272 273 274 275 ... 356 357

Komentarze do niniejszej Instrukcji

Brak uwag