ZyXEL Communications ZyAIR Podręcznik Użytkownika Pobierz pdf (Strona 122)

ZyAIR B-3000 User’s Guide

121 Chapter 13 LAN Setup

13.3.1 Configuring MAC Address Filter

Your ZyAIR checks the MAC address of the wireless station device against a list of allowed or

denied MAC addresses. However, intruders could fake allowed MAC addresses so MAC-

based authentication is less secure than EAP authentication.

Follow the steps below to create the MAC address table on your ZyAIR.

1 From the main menu, enter 3 to open Menu 3 – LAN Setup.

2 Enter 5 to display Menu 3.5 – Wireless LAN Setup.

Authen. Method Press [SPACE BAR] to select Auto, Open System Only or Shared Key Only and press

[ENTER].

This field is N/A if WEP is not activated.

If WEP encryption is activated, the default setting is Auto.

Edit MAC Address Filter Press [SPACE BAR] to select Yes and press [ENTER] to display Menu 3.5.1 - WLAN

MAC Address Filter.

Edit Roaming

Configuration

Press [SPACE BAR] to select Yes and press [ENTER] to display Menu 3.5.2 - Roaming

Configuration.

Edit Multiple ESS

Configuration

Use [SPACE BAR] to choose Yes and press [ENTER] to go to Menu 3.5.3 - Multiple ESS

Configuration.

Edit Bridge Link

Configuration

Use [SPACE BAR] to choose Yes and press [ENTER] to go to Menu 3.5.4 - Bridge Link

Configuration.

Block Intra-BSS Traffic Intra-BSS traffic is traffic between wireless stations in the same BSS. Select No to allow

Intra-BSS traffic, select Yes to block all Intra-BSS traffic.

Number of Association

Stations

Enter the number of association stations. The number should be from 1 to 32.

Breathing LED Select Yes to enable the Breathing LED, also known as the ZyAIR LED.

The blue ZyAIR LED is on when the ZyAIR is on and blinks (or breaths) when data is being

transmitted to/from its wireless stations. Clear the check box to turn this LED off even

when the ZyAIR is on and data is being transmitted/received.

Output Power Set the output power of the ZyAIR in this field. If there is a high density of APs within an

area, decrease the output power of the ZyAIR to reduce interference with other APs.

Press [SPACE BAR] to select 11dBm, 13dBm, 15dBm or 17dBm and press [ENTER].

Edit Layer 2 Isolation Press [SPACE BAR] to select Yes or No and press [ENTER].

When you have completed this menu, press [ENTER] at the prompt “Press ENTER to confirm or ESC to cancel” to

save your configuration or press [ESC] to cancel and go back to the previous screen.

Table 41 Menu 3.5 Wireless LAN Setup

FIELD DESCRIPTION

1 2 ... 117 118 119 120 121 122 123 124 125 126 127 ... 220 221

Komentarze do niniejszej Instrukcji

Brak uwag

ZyXEL Communications ZyAIR Podręcznik Użytkownika Strona 122

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Punkty dostępu do sieci WLAN ZyXEL Communications ZyAIR